;bdiGDB configuration file for T4240-QDS
;---------------------------------------
;
;
[INIT]
;


[TARGET]
; common parameters
POWERUP     5000                ;start delay after power-up detected in ms
JTAGCLOCK   16000000            ;16 MHz JTAG clock
RESET       HARD  1000          ;assert reset for 1 seconds
WAKEUP      500                 ;give reset time to complete
;
;===========================================================
; !!!! define the thread ID (the #x) without any holes  !!!!
; !!!! no need that thread ID matches the thread number !!!!
; !!!! A valid example is: #1 CPUTYPE  T4240 2 0        !!!!
;===========================================================
;
; ThreadID#0 parameters (active thread after reset)
#0 CPUTYPE      T4240 0 0       ;Thread#0 / SOC#0
#0 EDBCR0       EDM DNH CTH     ;set run parameters
;#0 STARTUP      HALT            ;halt at the reset vector (this halts all threads !!!)
#0 STARTUP      STOP 5000       ;let U-boot setup the system
#0 BREAKMODE    HARD            ;SOFT or HARD, HARD uses PPC hardware breakpoint
#0 STEPMODE     HWBP            ;ICMP or HWBP, HWBP uses a hardware breakpoint
;
; ThreadID#x parameters
#1 CPUTYPE      T4240 1 0
#1 EDBCR0       EDM DNH CTH
#1 STARTUP      RUN
;

[HOST]
FILE            E:\temp\dump256k.bin
FORMAT          BIN 0x01000000
;
#0 PROMPT       T4240#0>
#1 PROMPT       T4240#1>


[FLASH]


[REGS]
FILE        $regT4240.def