; bdiGDB configuration for Broadcom BCM4718 (Netgear WNR3500L)
; ------------------------------------------------------------
;
;
[INIT]
;
; Setup TLB
WTLB    0x00000700  0x0000001f  ;map DRAM to 0x00000000, cachable
;
; Invalidate Caches
;IVIC                            ;Invalidate IC
;IVDC                            ;Invalidate DC
;


[TARGET]
JTAGCLOCK   0                   ;use 16 MHz JTAG clock
CPUTYPE     M74K 		;the used target CPU type
RESET       JTAG		;reset signal is not routed on this board
WAKEUP      100                 ;give reset time to complete
ENDIAN      LITTLE              ;target is little endian
STARTUP     STOP 1000           ;STOP mode is used to let the monitor init the system
BREAKMODE   SOFT        	;SOFT or HARD, HARD uses PPC hardware breakpoints
STEPMODE    JTAG                ;JTAG, HWBP or SWBP
;WORKSPACE   0xA0000000	        ;workspace in target RAM for fast download
;VECTOR      CATCH               ;catch unhandled exceptions
;
; Switch to MIPS EJTAG TAP
SCANINIT    t1:w1000:t0:w1000:  ;toggle TRST
SCANINIT    ch10:w100:          ;clock TCK with TMS high
SCANINIT    i32=0143ff3a:
SCANINIT    d32=00000001:
SCANINIT    w100000
;


[HOST]
IP          151.120.25.119
PROMPT      BCM4718>
FILE        e:/temp/dump256k.bin
FORMAT      BIN 0xa0010000


[FLASH]
[REGS]
DMM1	0xFF300000      ;DSU base address
FILE	$reg74k.def