; bdiGDB configuration file for Cavium CN70xx
; -------------------------------------------
;
; This configuration allows to program only 4M byte flash
; in the range 0xbfc00000 ... 0xbfffffff.
; After reset the boot flash is mapped to 0xbfc00000.
;
; Note:
; On the CN7000-EVB make sure that switch SW4.7 is in the OFF position.
; Otherwise the on-board USB-EJTAG interface is selected.
;
;
[INIT]
;
WCP0    12                  0x504000e4          ;enable access to 64-bit segment
;
; Setup TLB (for test purpose only)
;WTLB    0xC000000c_0x10000500   0x01FC0017     ;Boot Flash 2 x  1MB, uncached DVG
;WTLB    0x40000004_0x20000500   0x01FC0017     ;Boot Flash 2 x  1MB, uncached DVG
;WTLB    0x00000005_0x30000500   0x01FC0017     ;Boot Flash 2 x  1MB, uncached DVG
;

[TARGET]
; common parameters
POWERUP     2000                ;power-up delay 5 seconds
JTAGCLOCK   16000000            ;use 16 MHz JTAG clock
RESET       HARD                ;hard reset via RST pin
;WAKEUP      100                 ;delay after hard reset released
;
;======================================================
; !!!! defines the cores numbers without any holes !!!!
;======================================================
;
; Core#0 parameters (active core after reset)
#0 CPUTYPE    CNMIPS3
#0 ENDIAN     BIG
#0 JTAGDELAY  10
#0 STARTUP    HALT              ;halt at the boot vector
#0 BREAKMODE  HARD
#0 WORKSPACE  0x80000000        ;workspace in L2 cache
#0 SCANPRED   3    15           ;select last core in scan chain
#0 SCANSUCC   0    0
;


[HOST]
FILE        E:/temp/dump256k.bin
FORMAT      BIN 0xA0001000
PROMPT      cnMIPS3#0>


[FLASH]
;Program boot flash S29GL064N-01 in 8-bit mode
;WORKSPACE   0x80001000          ;workspace in L2 cache
;CHIPTYPE    MIRRORX8            ;Flash type
;CHIPSIZE    0x00400000          ;The visible size of one flash chip in bytes
;BUSWIDTH    8                   ;The width of the flash memory bus in bits

;Only to test new flash algorithm
WORKSPACE   0x80001000          ;workspace in L2 cache
CHIPTYPE    S29WSRX16           ;Flash type
CHIPSIZE    0x00100000          ;The visible size of one flash chip in bytes
BUSWIDTH    16                  ;The width of the flash memory bus in bits
FILE        e:/temp/dump0080.bin
;FILE        e:/temp/dump8000.bin
FORMAT      BIN 0x80010000
ERASE       0x80010000



[REGS]
;used for all cores unless overridden
DMM1	0xFF300000              ;DSU base address
DMM2	0x80000000_0            ;xkphys segment
FILE	$regCNMIPS3.def